Adjusting the 3D Color Management
You can adjust the picture color quality by
selecting from 6 base color adjustments : Red,
Green, Blue, Yellow, Magenta ,Cyan or Reset.
1 From the PICTURE menu, press or to
select 3D Color Management.
2 Press or to select On.
3 Press or to select Base Color
Adjustment.
4 Press OK, then press or to select an item
you want to adjust.
5 Press , then press or to select Tint
Color or Brightness.
6 Press or to adjust the settings as required.
NOTE:
If you select 3D Color Management Off mode, this
mode is not available.
Resetting the Base Color Adjustment
The reset function adjusts the base color
adjustment to the factory settings.
1 From the Base Color Adjustment menu, press
or to select Reset.
2 Press OK.
3 A conrmation message will appear. Press or
to select Yes, and then press OK.
Setting the Dynamic Contrast
This feature enriches the picture contrast under
certain circumstances.
1 From the PICTURE menu, press or
to select Dynamic Contrast.
2 Press or to select On or Off.
Using the Film Mode
This feature will reduce picture blur without
decreasing image brightness or adding icker.
1 From the PICTURE menu, press or
to select Film Mode.
2 Press or to select On or Off.
Using the Active Backlight Control
In order to improve screen visibility, the Active
Backlight Control sets the screen brightness
automatically during dark scenes.
1 From the PICTURE menu, press or to
select Active Backlight Control.
2 Press or to select On or Off.
Activating the Noise Reduction & MPEG NR
If the receiving signal of MPEG is a mosquito
(grained) noise depending on the compression and
conversion, the picture is weak and the picture is
blurry, the picture may be improved when using this
function.
1 From the PICTURE menu, press or to select
Noise Reduction or MPEG NR.
2 Select Noise Reduction or MPEG NR, and then
press or to select Low, Middle, High or Off.
21
Magenta
Using the Auto View
This mode can adjust the brightness of the screen
image automatically according to indoor lighting
condition.
1 From the PICTURE menu, press or
to select Auto View.
2 Press or to select On or Off.
NOTE:
This feature is not available for 24inch TV .
To Next Page
Loading...
