Toshiba 40L365 Series - Page 24

Skip—Press the BLUE button to delete the
program.
Rename(ATV only)—Press the GREEN button to
rename the program.
SELECT—Add the favorite channel to the SELECT
list.
1 From the CHANNEL menu, press or to
select Signal Information and press OK.
2 Then the list of signal information will appear
as follows.
This option is only available in DVB-T source,
select On to supply power for the TV’s
antenna; Select Off to turn off this function.
Channel 54
100
96
(Good)
(Strong)
256QAM
NOTE:
When the signal Quality isGood,information will
appear as bellow.
NOTE:
While the signal Quality ispoor,information as
follows.
SWUpdate (OAD)
1 From the CHANNEL menu, press or to select
SWUpdate (OAD) and press or toselect
OnorOff.
2 Select On to allow the TV to update the system
software over the air. Select Off will turn off
this function.
NOTE:
This feature is onlyavailable for someregions.
Signal Information
This feature is available for displaying the on-screen
information.
24
4 Press EXIT can exit the searching process.
1 From the CHANNEL menu, press or to
select Program Edit.
Program Edit
Delete—Press the RED button to delete the
program.
Move—Press the YELLOW button to activate
the Move feature. Press the or buttons to
select the channel you wish to move and press
OK to check.
SELECT
3 Press OK to search for channels.
The channels will be searched and stored to the
channel list.
1 When you switch to DTV source, you can from
the CHANNEL menu, press or to select
DTV Manual Tuning and press OK.
2 Use or to change the settings.
• For DVB-T source, the number buttons can be
used to enter the RF number.
VHF CH 9
DTV 5
Radio 2
Data 0
Bad Normal Good
D
Auto
Symbol(ks/s)
Auto
QAM Type
DTV
Bad Normal Good
• While in DVB-C source,thenumber buttons
can be used to enter Frequency.