(1/18)
HOTEL MODE
1. ENTERING HOTEL MODE MENU
Hotel Mode Menu should be shown by the following operation.
1) Open Main Menu by pressing Menu button of RCU.
2) Press the following password number “1048” with the button of Remote Control.
Note: Hotel Menu can be displayed to input the password number when there is focus in the first layer of
Main Menu.
2. DISPLAY OF HOTEL MODE MENU
- The Graphic Design and color of Hotel Mode Menu is the same as the User menu.
(Small differences which do not affect to operation will be acceptable)
- The language will follow the “Menu Language” setting in the menu
(Fig.1; Example of Menu Image)
3. OPERATING HOTEL MODE MENU
- To enable Hotel Mode, press ▲/▼buttons to select “Hotel Mode” item and press button.
Press ▲/▼buttons to select “On” and press OK button.
- Once Hotel Mode is “On”, the Hotel Mode settings will be enabled for adjusting.
- Press ▲/▼ buttons to select item of Hotel Mode Settings.
Press and ▲/▼ buttons to select settings and press OK button.
See the table below for explanation of each setting.
- Press Exit when finished adjusting the settings.
To Next Page
Loading...
