21
Using the TV’s features
2 Press Y or Z, then press Y or Z to select
On.
3D Colour management On
3 Press Q, then press V or U to select Base
colour adjustment.
4 Press Q, then press V or U to select an
item you want to adjust.
Base colour adjustment
Hue Saturation Brightness
Red 0 0 0
000
000
000
000
000
Green
Blue
Yellow
Magenta
Cyan
Reset
5 Press Z, then press Y or Z to select Hue,
Saturation or Brightness.
6 Press V or U to adjust the settings as
required.
Hue Saturation Brightness
Red 0 00
Note:
If you select colour management Off mode, this
mode is not available.
Resetting the base colour adjustment
The reset function adjusts the base colour
adjustment to the factory settings.
1 From the Base colour adjustment menu,
press V or U to select Reset.
2 Press Q.
Using the active backlight control
In order to improve screen visibility, the active
backlight control sets the screen brightness
automatically during dark scenes.
1 From the PICTURE menu, press V or U to
select Active Backlight Control.
2 Press Y or Z to select On or Off.
Activating Auto Brightness Sensor
When auto contrast is activated it will
automatically optimize the backlighting levels to
suit ambient light conditions.
1 From the PICTURE menu, press V or U to
select Auto Brightness Sensor.
2 Press Y or Z to select On or Off.
2 Press Y or Z to select Cool, Natural, or Warm
to suit your preference.
Colour Temperature
Colour Temperature Cool
Red Level
Green Level
Blue Level
0
0
0
3 Press V or U to select Red Level, Green
Level or Blue Level, then press Y or Z to
adjust the setting as required.
Resetting the picture settings
This function returns the picture settings to the
factory settings.
1 From the Picture settings menu, press V or
U to select Reset on the 2nd page.
2 Press Q.
Activating the MPEG NR (Noise Reduction)
If the receiving signal of MPEG is a mosquito
(grained) noise depending on the compression
and conversion, the noise may be reduced when
using this function.
1 From the PICTURE menu, press V or U to
select MPEG NR.
2 Press Y or Z to select Off, Low, Middle or
High.
MPEG NR Low
Activating the DNR (Digital Noise
Reduction)
If the receiving signal is weak and the picture is
blurry, the picture may be improved when using
this function.
1 From the PICTURE menu, press V or U to
select DNR.
2 Press Y or Z to select Auto, Off, Low,
Middle or High.
DNR Auto
Note:
This function is available for 480i and 576i
signals.
Adjusting the colour management
You can adjust the picture colour quality by
selecting from 6 base colour adjustments : Red,
Green, Blue, Yellow, Magenta or Cyan.
1 From the PICTURE menu, press V or U to
select 3D Colour management.
324246RV600ETY_En.indd 21324246RV600ETY_En.indd 21 7/28/2009 10:08:14 AM7/28/2009 10:08:14 AM
To Next Page
Loading...
