— :
A/D adjustment is not needed because the picture format is not used.
9 A/D Adjust COMP A/D adjustment status for Component input
OK :
A/D adjustment is set correctly.
NG :
A/D adjustment is not set correctly.
— :
A/D adjustment is not needed because the picture format is not used.
10 A/D Adjust RGB A/D adjustment status for SCART and PC input
OK :
A/D adjustment is set correctly.
NG :
A/D adjustment is not set correctly.
— :
A/D adjustment is not needed because the picture format is not used.
11 POT (Power On Time) Total time the TV has been powered on. (Unit: Hours) (Decimal)
Stand by mode (AC is on, but Panel is off) is not included.
The value is reset to 0 only when receiving the ship out code.
After power on, count up when 1 hour passed.
No need to memory the 0-59 minutes.
12 AST (AC Supply time) Total time the TV has been plugged in. (Unit: Hours) (Decimal)
Stand by mode (AC is on, but Panel is off) is included.
Others are same as POT
13 MAIN Format Video Format Information
14 MAIN Tuner Freq. Displays tuned frequency (Unit: kHz) (Decimal)
15 Sticker Demo Version information of Sticker Demo data
16 MAC address Media Access Control (MAC) address.
Display is in the format: xx:xx:xx:xx:xx:xx (Hex)
17 Dynamic Addressing Status of Dynamic Host Configuration Protocol (DHCP) Configuration.
TRUE: IP address will be automatically configured if the TV is connected to a network that supports DHCP
false : IP address must be manually set to a static IP address
18 IP address Current Internet Protocol (IP) address.
Display *.*.*.* format (* is decimal)
19 Subnet mask Current Subnet Mask.
Display *.*.*.* format (* is decimal)
20 DLNA Check Total Number of Successful DLNA factory tests. (Decimal)
21 CI+ Serial Number Serial Number of CI+ data
Display 4 byte data.(Hex)
22 CI+ Host ID Host ID of CI+
Display 8 byte data.(Hex)
23 MainBoard Temp Temperature of MainBoard
The value from temperature sensor.
Display -040.0−125.0 (Decimal)
To Next Page
Loading...
