26
9 Mode setting for Smart Manager with data
analyzer
Operation mode
You can switch the functional mode of the Smart Manager with data analyzer between the central control mode
and remote control mode. The mode is switched with the dip switch DS23-<6>.
Control group selection
An arbitrary range of a line and 16 groups (1 to 16, 17 to 32, 33 to 48, and 49 to 64) can be selectively set.
* When the control group selection is not used (“ALL group”), all groups and zones on LINE 1 and LINE 2 can be
controlled.
* When the control group selection is used, only groups and zones in the set group range can be controlled.
• When the control group selection is used, groups and zones outside this range are not displayed and cannot
be operated.
• means the entire set group range.
• Zones can be registered and operated only within the set group range. (No groups outside the range can be
registered or operated.)
• The group control mode is available only for one line.
* Multiple group ranges can be specified by the control group setting.
OFF side: Central control mode
This Smart Manager with data analyzer is used as a central control unit.
Settings with the remote controller are inhibited by the setting of the Smart Manager with data analyzer.
ON side: Remote control mode
This Smart Manager with data analyzer is used as a remote controller.
Settings with the Smart Manager with data analyzer are inhibited by the setting of another central
control unit.
DS23 DS24
<2><3><4><5><5><6>
All groups OFF OFF OFF OFF OFF OFF
LINE 1
Group 1 to 16
ON OFF OFF OFF OFF ON
Group 17 to 32 OFF
ON OFF OFF OFF ON
Group 33 to 48 OFF OFF
ON OFF OFF ON
Group 49 to 64 OFF OFF OFF
ON OFF ON
LINE 2
Group 1 to 16
ON OFF OFF OFF ON ON
Group 17 to 32 OFF
ON OFF OFF ON ON
Group 33 to 48 OFF OFF
ON OFF ON ON
Group 49 to 64 OFF OFF OFF
ON ON ON
Example:
When setting LINE 1 (group 1 to 32) in
the control group selection
ON ON OFF OFF OFF ON
(Example) When groups 33 to 48 and groups 49 to 64 are specified at the same time, a group range (groups
33 to 64) is set by the control group setting.
To Next Page
Loading...
