Toshiba CF27H50 - Connecting a VCR with an S-Video Jack; S-Video Input Source Selection

Connecting a VCR with an S-Video Jack
If you connect a VCR with an S-video jack to the S-VIDEO jack on the back of the TV, you must also connect the audio
cables to the AUDIO jacks of the VIDEO 1 IN jacks on the back of the "IV. The S-video cable only carries the video signal.
Audio signals are separate.
Antenna/Cable
lead-in
Antenna
output VCR
Back of "IV
INm I
VIDE01 VIDE02
v,oEo@___
AUDIO I"
I I
Audio
outputs
S-video cable (not supplied)
Audio cable (not supplied)
OUT
EO
AUDI
ANT
(75_)
@
1 Turn the "IV and VCR ON.
2 Press the TV/VIDEO button to select "VIDEO 1".
TV
VIDEO 1
VIDEO 2
TO SELECT PUSH TVIVIDEO
Notes:
• When the S-video cable is connected to the S-VIDEO IN
jack, the video cable (phono-type) should not be
connected.
• The S-VIDEO jack accepts SEPARATED Luminance/
Chrominance (Y-C) signals conforming to the NTSC
standard.
3 Operate your VCR normally.
0
o
-a
>
|
03
>
t-
O
e"
®
e-
e"
o
33