programming Channel Memory
The channel memory is a list of TV channel numbers your "iV will stop on when you press the CHANNEL • or • button.
First, use the W/CABLE and CH PROGRAM functions to preset all active channels in your area.
If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into only desired
channels,
-CHA_NEL •/•
/
MENU TVNIDEO VOLLKE r_ POWER
MENU </1_/•/• POWER
1 Press POWER to turn on the -IV,
2
3
Press MENU repeatedly until the Setup
menu is displayed on the screen.
Press • or • until "TV/CABLE" is
displayed in purple.
_ .."_EB: u _,'',
TV/CABLE: {TV JCABLE
C_'i L:_'3K
TO SELECT ITEM PUSH • &
TO CONTROL PUSH <
•/T
RECALL
@
@
®
®
@
POWER
®®
@®
®®
.</1_
FAV CH TVNIOEO
TVNCR STOP PLAy
SLOW PAUSE _ FF
LOCATE SWAP
TOSHIBA
MENU
4
Press < or I_ until the mode that corre-
sponds to your TV signal system is
displayed in purple.
TV: TV broadcasts signals.
(VHF channels 2 through 13 and
UHF channels 14 through 69)
CABLE: Cable "IV signals.
Cable channels 1 through 125)
2
PressMENU repeatedly untilthe Setup
menu isdisplayed on the screen.
Press • or • until "CH PROGRAM" is
displayed in purple.
3
Press • or I_ to start channel program-
ming.
The TV will automatically cycle through
all theTV or CABLE channels
depending on the mode selected, and
store active channels in the channel
memory.
4 When channel programming is complete,
you will see the message at the right.
;L.', ¢_LE TV [CABLE l
TO SELECT ITEM PUSH • •
TO CONTROL PUSH 4 I_
TO SELECT ITEM PUSH • •
TO CONTROL PUSH ,11 I_
CH PROGRAM
TV 24
TV
5 Press CHANNEL • or • to make sure the channel programming has
been done properly.
15
To Next Page
Loading...
