Toshiba D-KVR20U - DVD TO VCR AND VCR TO DVD DUBBING; Dubbing Preparation Notes

49EN 49EN
Disc
Management
Recording
PlaybackIntroduction Connections Basic Setup Editing Function Setup VCR Function Others
DVD/VCR DUBBING
1
Press [SETUP] and use [K / L] to
select “General Setting”, then press
[ENTER].
“General Setting” menu will appear.
2
Use [K / L] to select “Recording”,
then press [ENTER].
“Recording” menu will appear.
3
Use [K / L] to select “Dubbing
Mode”, then press [ENTER].
Selection menu will appear.
You can copy a DVD to a cassette tape or copy a cassette
tape to a DVD. This function will be possible only if the
DVD or the cassette tape is not copy protected.
Before starting this function, prepare for the recording on
the DVD-RW/-R or the cassette tape. Refer to pages 33
and 99.
Make sure:
• Insert a recordable disc and a cassette tape with an
erase-protection tab.
Note for recording to a cassette tape:
• The cassette tape's erase-protection tab is intact.
• The remaining time of the cassette tape is long enough.
Note for recording to a disc:
• Make sure that the disc is recordable. Refer to page 9.
SE-R0295
OPEN/
CLOSE
INPUT
SELECT
HDMI
.@/: ABC
GHI
PQRS TUV
SPACE
SETUP DISPLAY AUDIO
TIMER
PROG.
DISC MENU
CLEAR RETURN
TOP MENU
WXYZ
SAT.LINK
JKL MNO
DEF
TRACKING
ENTER
INSTANT
SKIP
PLAY
DVDVCR
PAU S E
REV
SKIP
STOP SKIP
FWD
1.3x/0.8x
PLAY
TIME SLIP
TIMER SET ZOOMSEARCHREPEAT
RECREC MODEDUBBING
ENTER
PAUSE
PLAY
SETUP
STOP
TOP MENU
DUBBING
DVDVCR
Instructions continue on the next page.
E9KGBUD_D-KVR20KU_EN.indd 49E9KGBUD_D-KVR20KU_EN.indd 49 2008/05/27 16:10:492008/05/27 16:10:49