Do you have a question about the Toshiba DP5130-SDL and is the answer not in the manual?
Type | IP Phone |
---|---|
Speakerphone | Yes |
Headset Jack | Yes |
Audio Codec | G.711, G.729 |
Network Interface | Ethernet |
Power over Ethernet | Yes (IEEE 802.3af) |
Supported Protocols | SIP |
Describes physical design, large LCD displays, and backlight options for enhanced user experience.
Covers integrated and add-on LCD key modules, their programmability, and labeling.
Explains handset/mic mute functionality and simultaneous mute operation.
Lists other features like high-contrast LCD and built-in headset interface.
Details various desk and wall mount tilt positions for different models.
Details environmental conditions for operation and storage of telephones and modules.
Outlines necessary CIX Basic Port License and migration licenses for specific models.
Explains cabling requirements, line cord types, and connection best practices.
Provides maximum cable lengths for various models and configurations on specific systems.
Specifies maximum cable lengths for CIX40 systems, noting wiring requirements.
Lists the -24 VDC power factor for telephones and add-on modules.
Identifies and explains the purpose of ADM, Line Cord, Ext. Speaker, Headset, and Handset connectors.
Details the general procedure for wall mounting telephones using screws.
Provides specific steps for wall mounting the DP5008 model.
Steps to perform a factory reset and re-initialize a DP5000 series telephone.
Instructions for assigning and programming LCD keystrip labels for the DP5130-SDL.
General procedure for assigning features and custom labels to keystrip buttons via eManager.
Instructions for assigning LCD keystrip resources for the LM5110 add-on module.
Steps to program custom labels for the LM5110 module's LCD keys.
Instructions for adjusting handset and speaker volume for most DP5000 telephones.
Specific instructions for adjusting handset and speaker volume for the DP5008 model.
Details how to adjust backlight behavior (always on, synchronized) and delay times.
Steps to change the brightness level of the LCD backlight.
Instructions for modifying the LCD contrast on specific models and modules.
Explains the operation of the Mic/Mute key for muting the microphone and handset.
Steps for programming custom labels on LCD keystrips for DP5130-SDL and LM5110.