29597AA 35
Auto Sequence Setting
Auto Sequencing is available either in the Display screen when Auto Sequencing has been enabled or when a Spot-Monitor out signal
is used to display on a spot monitor. Auto Sequencing conveniently displays video channels at specified intervals and sequences
through each selected channel.
Custom Mode Create non-standard screen divisions
Skip 0 FPS Channel Sequence skips cameras with no video signal
Create Custom Auto Sequence
1. Open General setup and click Sequence Setting.
2. Click individual cameras in the left pane or click Select All to include all cameras in the sequence.
3. Select an Interval time (in seconds) to display each screen in the sequence.
4. Select screen division options for appropriate cameras.
Screen Division Options
Enable All Cameras
Enable Sequencing
Select interval between
switching cameras
To Next Page
Loading...
