29597AA 45
SENSOR SETUP
The Sensor setup window allows you to enable, disable and configure Sensors and Relays (Control Outputs).
Configure Sensor Response
1. Click Setup on the Display screen.
2. Click Sensor.
3. Click the NO or NC check box to select Normally Open or Normally Closed for the desired sensor.
4. Enter the Delay time to define the number of seconds after the sensor is tripped until the relay is activated.
5. Enter the Relays to associate with the sensor. One or more relays can be associated with a single sensor – separate with
commas.
6. Click Apply.
Configure Hybrid (IP) Sensors*
Normally Open (NO)
Normall
Closed
NC
Open On-Screen Keyboard
ssociate Sensor w/ PTZ Presets
Delay Triggering Relay Outpu
Assign Relay(s)
comma delineated
To Next Page
Loading...
