e-STUDIO200L/202L/230/232/280/282 SCANNER June 2004 © TOSHIBA TEC
6 - 28
[N] Scanning section control PC board (SLG board)
Notes:
When installing the scan motor, use the belt
tension jig (spring). The procedure is as fol-
lows.
1. Fix the screw A.
2. Temporarily fix the screw B and C.
3. Hook the belt tension jig to the motor
bracket and the flame.
4. The scan motor is pulled by the belt ten-
sion jig. Fix the screw B and then C at the
stopped position.
5. Remove the belt tension jig.
Fig. 6-48
(1) Take off the lens cover
(! P.6-18 "[B] Lens cover")
(2) Disconnect 8 connectors from the SLG
board.
(3) Remove 6 screws and take off the SLG
board.
Note:
The SLG board for e-STUDIO200L/230/280
series and the one for e-STUDIO202L/232/
282 series are different. To avoid confusion,
the color of the connector CN19 on the SLG
board for e-STUDIO202L/232/282 series is
yellow.
Fig. 6-49
Belt tension jig
A
B
C
SLG board
05/11
To Next Page
Loading...
