Toshiba e-studio 2309a

Other manuals for Toshiba e-studio 2309a

Software Installation Guide48 pages

Safety Information148 pages

Questions and Answers

C
Christina AndersonAug 16, 2025
Why does my Toshiba All in One Printer say 'MEMORY IS FULL'?
- J
  Joshua McdanielAug 16, 2025
  The 'MEMORY IS FULL' message on your Toshiba All in One Printer indicates that the memory became full during data entry into memory during a transmission. To resolve this, press any key to restore the idle state. If the memory is full during transmission, wait for it to become available and retry, or perform direct transmission. If the memory is full during reception, contact the other party to re-transmit the document.
K
kbutlerAug 19, 2025
What to do if my Toshiba All in One Printer displays 'DRAWER # EMPTY ADD PAPER'?
- D
  Daniel ThompsonAug 19, 2025
  The 'DRAWER # EMPTY ADD PAPER' message on your Toshiba All in One Printer means that the designated drawer has run out of paper or the drawer is removed. To fix this, load recording paper or insert the drawer firmly. Note that memory reception may be performed, so do turn off the power.
J
James HarrellAug 22, 2025
What to do if my Toshiba All in One Printer shows the error 'MISFEED Exxx'?
- J
  Jennifer BrownAug 22, 2025
  The error 'MISFEED Exxx' on your Toshiba All in One Printer indicates an original or paper misfeed. An error code “xxx” and a message for solving the problem are displayed. Remove any misfed original or paper to clear the error.
E
Elizabeth HerreraAug 26, 2025
What does 'COUNT OVER' mean on my Toshiba All in One Printer and how to fix it?
- A
  Angela JonesAug 26, 2025
  The 'COUNT OVER' message on your Toshiba All in One Printer means that the number of pages scanned has exceeded the maximum value (50 sheets). You can either 'CANCEL JOB' to cancel the count over, or select 'SEND' to stop the scan function and send the scanned images already stored in memory.
M
Michelle JamesAug 28, 2025
Why does my Toshiba All in One Printer say 'PUT DOCUMENT FEEDER DOWN'?
- K
  Katie BenjaminAug 28, 2025
  The message 'PUT DOCUMENT FEEDER DOWN' on your Toshiba All in One Printer indicates that the RADF (Reversing Automatic Document Feeder) or its cover has been left open after placing the originals. To resolve this, close the RADF or the cover.
L
Lisa McdanielAug 31, 2025
What does 'FAX ERROR xxxx' mean on my Toshiba All in One Printer?
- K
  Kathleen MedinaAug 31, 2025
  The 'FAX ERROR xxxx' message on your Toshiba All in One Printer indicates that a communication error occurred during transmission or reception. You should try sending or receiving again.
M
Marvin EvansSep 3, 2025
What does 'LOAD XX' mean on my Toshiba All in One Printer?
- D
  donna83Sep 3, 2025
  The 'LOAD XX' message on your Toshiba All in One Printer (Only for e-STUDIO2809A Series) indicates that there is no appropriate paper for the received original. Change the paper size setup to match the request.
L
lesliecastanedaSep 6, 2025
What does 'PUT ORIGINAL ON GLASS' mean on my Toshiba All in One Printer?
- T
  tina72Sep 6, 2025
  The message 'PUT ORIGINAL ON GLASS' on your Toshiba All in One Printer means that an original was detected in the RADF feed tray when "NEXT ORIGINAL?" was displayed. Remove the original from the RADF feed tray.
R
Robert AyersSep 9, 2025
Why does my Toshiba All in One Printer say 'HUNG UP THE PHONE'?
- L
  Lisa ParkerSep 9, 2025
  The message 'HUNG UP THE PHONE' on your Toshiba All in One Printer indicates that the external telephone is busy for a long time. Hang up the external phone.
J
Joseph EdwardsSep 12, 2025
What does 'ERROR:CHECK COPY MODE' mean on my Toshiba All in One Printer?
- E
  espinozakennethSep 12, 2025
  The 'ERROR:CHECK COPY MODE' message on your Toshiba All in One Printer indicates that an error such as misfeed or toner empty has occurred. Press the [COPY] button to confirm the error. For details, refer to the User’s Guide.

Summary

General Precautions

Disclaimer of Liability

Outlines TOSHIBA TEC CORPORATION's limitations of liability for product use and damage.

1 BEFORE USING FAX

Control Panel Overview

2 SENDING A FAX

Basic Procedures

Step-by-step guide for sending a fax, including original placement and recipient selection.

Setting Transmission Conditions

Configures settings like resolution, original mode, and exposure for fax transmission.

Specifying Recipients

Outlines methods for selecting fax destinations, including direct entry, address book, and speed dial.

Managing Transmissions

3 RECEIVING A FAX

Reception Modes

Explains automatic, manual, and remote reception methods for incoming faxes.

Originals and Paper Handling

5 SENDING A N;W-FAX

Network Fax Features and Functions

Overview of network fax capabilities, including sending electronic documents and cover sheets.

Faxing from Applications

Guides on sending faxes directly from computer applications using the N/W-Fax driver.

Managing Network Address Book

Setting Network Fax Options

6 SETTING ITEMS

Operating User Functions Menu

Terminal ID Registration

Address Book Management

7 TROUBLESHOOTING AND SPECIFICATIONS

Troubleshooting Common Issues

Provides solutions for common operational problems and error messages.

Fax Specifications

Toshiba e-studio 2309a Specifications

General

Print Technology	Laser
Print Speed	23 ppm
Print Resolution	2400 x 600 dpi
Scan Resolution	600 x 600 dpi
Copy Speed	23 cpm
Paper Capacity	250 sheets
Monthly Duty Cycle	20, 000 pages
Connectivity	USB 2.0
Paper Size	A3, A4, A5, B4, B5
Warm-Up Time	Approx. 18 seconds
First Print Time	Approx. 6.4 seconds
Memory	512 MB
Duplex Printing	Manual
Max Paper Size	A3
Interface	USB 2.0
Dimensions	575 x 540 x 402 mm
Functions	Print, Copy, Scan