2 SENDING A FAX
24 Basic Procedures
Redial function
In the transmission mode, if the fax cannot be sent due to a busy-line, the fax number is
redialed automatically to send the fax. If you want to change the number of times the
equipment will redial, contact your service technician.
Sending the next original
If an original is placed on the original glass and its scanning is completed, the confirmation
screen for the next original is displayed. To continue scanning the next original, set the original,
select [SCAN NEXT PAGE], and then press [OK]. Once all originals have been scanned, select
[FINISHED] with , and then press [OK].
If you leave the screen unattended for the set auto clear time (45 sec. by manufacturer
default), a copy of the scanned originals is sent.
To cancel the transmission, press [CLEAR/STOP].
P.45 “Canceling transmission when an original is being scanned”
Sending a Fax after calling the recipient
This section describes how to send a fax after you have called the recipient using the external
telephone and confirmed that there is someone there.
It is necessary to have the setting of the equipment changed by service technicians in
advance. Moreover, connect the external telephone to the TEL terminal.
Instead of picking up the handset of the external telephone, by pressing the
[MONITOR] button with the following procedure, you can carry out the same operation.
1
As for normal fax transmission, place the original, press [FAX] to
switch to the fax screen and set the transmission conditions.
P.22 “Basic Procedures”
2
Pick up the handset of the external telephone.
4
1
100%
SCAN NEXT PAGE
NEXT ORIGINAL?
FINISHED
TEXT/PHOTO
A4
1
100%
TALKING M:100%
:INPUT FAX NUMBER
AUTO EXPOSURE
TEXT/PHOTO
To Next Page
Loading...
