11
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 DRUM RELATED SECTION
11 - 11
[D] Main charger
[E] Main charger grid
(3) Release the harness from the harness clamp
and pull out the discharge LED.
Fig.11-12
(1) Take off the discharge LED unit
(! P.11-10 "[C] Discharge LED").
(2) Pull out the main charger and take it off by
sliding it to the rear side.
Note:
Be careful not to touch or scratch the drum
surface at this time.
Fig.11-13
(1) Take off the main charger
(! P.11-11 "[D] Main charger").
(2) Remove the spring and take off the main
charger grid.
Note:
Do not touch the mesh area of the grid.
Fig.11-14
Discharge LED
Main charger
Main charger grid
Spring
To Next Page
Loading...
