e-STUDIO200L/202L/230/232/280/282 DRUM RELATED SECTION June 2004 © TOSHIBA TEC
11 - 14
[J] Drum separation finger
[K] Recovery blade
(1) Take off the drum
(! P.11-13 "[H] Drum").
(2) Remove 1 screw of each unit to take off the
drum separation finger units (3 pc.).
Notes:
1. When replacing the drum separation fin-
gers, make sure that the drum has been
taken off first since the fingers may
scratch the drum surface.
2. In e-STUDIO202L/232/232S/282/282S,
2 drum separation finger units are
installed.
Fig.11-20
(3) Remove the spring and take off the drum
separation fingers.
Note:
When the drum separation fingers have been
replaced, check if the pressure movement is
normal by moving them with your hands.
Fig.11-21
(1) Take off 3 drum separation finger units
(! P.11-14 "[J] Drum separation finger").
(2) Remove 2 screws, and take off the whole
recovery blade with the bracket.
Fig.11-22
Drum separation finger unit
Drum separation finger
Recovery blade
05/11
To Next Page
Loading...
