e-STUDIO200L/202L/230/232/280/282 POWER SUPPLY UNIT June 2004 © TOSHIBA TEC
16 - 4
The followings are two output channels which are linked with the door switch.
1) +5.1V
+5.1VD : CN706 Pin 2
Output to the LGC board
2) +24V
+24VD1 : CN706 Pins 11, 12, 13 and 14
Output to the LGC board, PFP/LCF (via LGC board)
+24VD1 : CN707 Pins 15 and 16
Output to the main motor
+24VD2 : CN706 Pins 5 and 6
Output to the LGC board, High-voltage transformer (via LGC board),
Bridge unit / Job separator / Offset tray (via LGC board)
+24VD2 : CN707 Pins 11 and 12
Output to the ADU board
+24VD3 : CN708 Pins 23 and 24
Output to the RADF
+24VD4 : CN708 Pins 19 and 20
Output to the SLG board
+24VD5 : CN707 Pin 8
Output to the finisher
<<Output connector>>
Not linked with the door switch
Linked with the door switch
Connector Destination Voltage
CN705 For the SYS board +3.3VA, +3.3VB, +5.1VA, +5.1VB,
+12VA, +12VB, -12VA, -12VB
CN706 For the LGC board, FUS board, PFP/LCF (via LGC
board), Bridge unit / Job separator / Offset tray (via
LGC board)
+3.3VB, +5.1VB, +12VB
CN707 For the finisher +5.1VB
CN708 For the SLG board, RADF +3.3VB, +5.1VB, +12VB
Connector Destination Voltage
CN706 For the LGC board, High-voltage transformer (via
LGC board), PFP/LCF (via LGC board), Bridge unit /
Job separator / Offset tray (via LGC board)
+5.1VD, +24VD1, +24VD2
CN707 For the ADU board, finisher +24VD1, +24VD2, +24VD5
CN708 For the SLG board, RADF +24VD3, +24VD4
To Next Page
Loading...
