312
10.WHEN THIS MESSAGE APPEARS
7.“Check paper size setting on control panel for drawer N” (Cont.)
10
5
See the size indication on the touch panel to check the paper size reg-
istered for the drawer mentioned in the message.
6
Place the paper, whose size is same as the one you have checked at
step 5, in the drawer mentioned in the message.
P.43 “4.Setting Copy Paper”
7
The job is resumed.
• If you change the paper size again after the completion of the job, check that the paper size placed in the
drawer is the same as the one registered in the equipment for the corresponding drawer.
3
Pull out the drawer mentioned in the
message. Then remove all the paper in it.
4
Close the drawer and then turn the power
ON.
To Next Page
Loading...
