Toshiba E-STUDIO 3028A - Saving Energy When Not in Use - Energy Saving Modes

1.Information About Equipment
20 Turning On/Off
When turning the equipment back on after turning it off, wait for approximately 30 seconds.
 Saving energy when not in use – energy saving modes –
The following modes are available; Automatic Energy Save mode, Sleep mode, and Super Sleep mode. The table
below shows the procedures to switch modes manually and conditions under which it enters into or recovers from
each mode.
*1 The default value is 1 minute.
*2 The [ENERGY SAVER] button on the control panel.
*3 Any of IPX and other protocols. When the IPsec function is enabled, the equipment enters Sleep mode.
For details, see the reference below:
TopAccess - [Administration] - [Setup] Item List - General settings - Setting up Energy Save
*4 Depending on the network environment, the time for switching to Super Sleep mode may take more than 10 minutes even if it is set to 10
minutes or less.
*5 The motion sensor can be used only for some models. For details, see the reference below:
 P.14 “Motion Sensor”
To change the time for entering each mode, see the reference below:
User Functions - SETTING ITEMS (Admin) - General - Setting the energy saver modes
Energy saving
modes
Procedure to
switch modes
Conditions to enter
into the mode
Status of equipment
Conditions to
recover from the
mode
Automatic Energy
Save mode
When a specified
period of time
*1
has passed since
the last use of the
equipment.
— A message is displayed
to indicate the energy
saving status.
When you press a
button on the control
panel. When print or
fax data are received.
When the ADF or
original cover is open.
When an original is
detected by the ADF.
Sleep mode When a specified
period of time
*1
has passed since
the last use of the
equipment or
when you press
the [ENERGY
SAVER] button
*2
.
When a particular
protocol
*3
is enabled.
The touch panel
display turns off. The
[ENERGY SAVER]
button turns green.
Same as the Automatic
Energy Save mode.
Super Sleep mode When a condition
to shift into the
super sleep mode
is satisfied
*1 *4
.
When particular
protocol and setting
*3
are disabled.
The touch panel
display turns off. The
[ENERGY SAVER]
button turns green.
When you press the
[ENERGY SAVER]
button on the control
panel.
When print or fax data
are received through a
wired LAN.
When the time set for
Scheduled Print has
come.
When the motion
sensor
*5
detects the
approaching of a
person.