1.TROUBLESHOOTING FOR THE HARDWARE
Refilling With Staples 69
1 TROUBLESHOOTING FOR THE HARDWARE
6
Close the front cover of the finisher.
If the message “Check staple cartridge” remains, repeat the procedure above from steps 1 to 6.
Inner Finisher MJ-1032
5
Fit the staple cartridge into the stapler.
When fitting the staple cartridge, hold the green-labeled portion of the
bracket securely so that the bracket will not move.
Insert the cartridge until it is caught by the latch and fixed with a click.
1
Lift up the control panel and then open the front cover
of the finisher.
2
While holding the green lever, move the finisher to the
left until it stops.
3
Open the Hole Punch Unit while pushing the green
lever.
To Next Page
Loading...
