Toshiba e-STUDIO 306 - Options

Chapter 6 INFORMATION ABOUT EQUIPMENT
Options
The following options are sold separately, and upgrade the performance of the equipment if installed. For details,
contact your service technician or representative.
68
1. Original Cover (KA-1640PC)
This is used to hold an original.
2. Reversing Automatic Document Feeder
(MR-3021, MR-3022)
This unit automatically feeds a stack of originals one by
one to have them copied. Install the MR-3021 in the
e-STUDIO206L/256/306, e-STUDIO256SE/306SE, and the
MR-3022 in the e-STUDIO356/456/506,
e-STUDIO356SE/456SE/506SE.
3. Bridge Unit (KN-2520)
This unit acts as a relay for the Finisher and this equipment .
4. Job Separator (MJ-5004/MJ-5006)
Enables Faxes, copies and prints to be output onto
separate paper trays.
Install the MJ-5004 in the e-STUDIO206L/256/306,
e-STUDIO256SE/306SE, and the MJ-5006 in the
e-STUDIO356/456/506, e-STUDIO356SE/456SE/506SE.
5. Oset Tray (MJ-5005)
Enables copied and printed sets to be collated or stacked
in groups with each set being oset.
6. Paper Feed Pedestal (KD-1025)
This pedestal enables you to install the Additional Drawer
Module (optional, MY-1033).
7. Large Capacity Feeder (KD-1026)
This feeder enables you to feed up to 2000 sheets (80 g/m
2
or 20 lb. Bond) of A4 or LT paper.
8. Additional Drawer Module (MY-1033)
This drawer can be added to the Paper Feed Pedestal
(optional, KD-1025). Combined with the 2 drawers in the
equipment, paper can be fed from 4 drawers in total.
9. Finisher (MJ-1101)
This Finisher enables sort/group nishing and stapling.
The Hole Punch Unit (optional, MJ-6103) can be installed
in this Finisher. The Bridge Unit (KN-2520) is required for
the installation of this Finisher.
10. Saddle Stitch Finisher (MJ-1106)
This Finisher enables saddle stitching, in addition to sort/
group nishing and stapling. The Hole Punch Unit
(MJ-6103) can be installed in this Finisher. The Bridge Unit
(KN-2520) is required for the installation of this Finisher.
11. Saddle Stitch Finisher (MJ-1033)
This Finisher enables saddle stitching, in addition to sort/
group nishing and stapling. The Hole Punch Unit
(MJ-6008) can be installed in this Finisher. The Bridge Unit
(KN-2520) is required for the installation of this Finisher.
e-STUDIO506/506SE does not support this option.
12. Inner Finisher (MJ-1032)
This Finisher enables sort/group nishing and stapling
The Hole Punch Unit (MJ-6007) can be installed in this
Finisher.
e-STUDIO506/506SE does not support this option.
678
3
4
5
15
9
12
14
11 13
10
12
For e-STUDIO206L/256/306/356/456/506,
e-STUDIO256SE/306SE/356SE/456SE/506SE
For e-STUDIO356/456/506,
For e-STUDIO206L/256/306,
e-STUDIO256SE/306SE
e-STUDIO356SE/456SE/506SE