Toshiba E-STUDIO 3525AC - Page 11

1.Information About Equipment
Description of Components 11
Information About Equipment
MJ-1113
1. Upper receiving tray
2. Stapling control section
3. Hole Punch Unit MJ-6107E
4. Front cover
5. Sub-tray
6. Lower receiving tray
7. Tray holder
 Open the tray holder when an attempt to output paper, which has a length longer than that of A3, is made or if the
paper on the upper receiving tray does not align itself neatly. The output paper will be more likely to be aligned
properly.
 Pull out the sub-tray when an attempt to output paper, which is longer than the lower receiving tray, is made. The
output paper will be more likely to be aligned properly.
MJ-1114
1. Upper receiving tray
2. Stapling control section
3. Hole Punch Unit MJ-6107E
4. Front cover
5. Stopper
6. Saddle stitch tray
7. Sub-tray
1
2
5
6
7
3
4
2
9
7
1
8
3
4
6
5