1.Information About Equipment
14 Description of Components
Adjusting the angle of the control panel
You can adjust the angle of the control panel between 7 and 90 degrees from the horizontal position.
Be careful not to catch your hands in the gap between the equipment and the control panel.
This could cause an injury.
Motion Sensor
A motion sensor is equipped on the left front side of the equipment for the following models.
e-STUDIO5525AC/6525AC
This equipment recovers from the sleep mode when a person is approaching, and thus can be used straightaway.
The sensing range is 3 levels: close, normal and far.
To Next Page
Loading...
