Toshiba E-STUDIO 555 - Clearing a Staple Jam; Staple Jam in the Finisher MJ-1027; Saddle Stitch Finisher MJ-1028

1 TROUBLESHOOTING FOR THE HARDWARE
Clearing a Staple Jam 31
Clearing a Staple Jam
When a staple jam has occurred in the stapler of the finisher or saddle stitch unit, clear the jam following the procedure
below.
 P.31 “Staple jam in the Finisher MJ-1027 / Saddle Stitch Finisher MJ-1028”
 P.32 “Staple jam in the Saddle Stitch Finisher MJ-1029”
 P.34 “Staple jam in the saddle stitch unit”
 Staple jam in the Finisher MJ-1027 / Saddle Stitch Finisher MJ-1028
1
Open the front cover of the finisher.
2
Lower the lever of the stapler to release the lock, and
then take out the staple cartridge.
3
Lower the guide while holding the knob.
Do not touch the stapling area (A in the figure).
The actual needle point could cause you personal injury.
4
Remove any jammed staples with something sharp.
1
2
A