1.TROUBLESHOOTING FOR THE HARDWARE
Refilling With Staples 43
1 TROUBLESHOOTING FOR THE HARDWARE
7
Close the front cover of the finisher.
If the message “Check staple cartridge” remains, repeat the procedure above from steps 1 to 7.
Refilling Saddle Stitch Finisher MJ-1029 staples
The Saddle Stitch Finisher MJ-1029 has two types of staple cartridges; one is for 100-sheet staples and the other is for
50-sheet ones. If you replace the staple cartridge with the other type, turn the power of the equipment OFF and then
back ON after replacing it.
5
Pull out the seal bundling the staples straight.
6
Fit the staple cartridge into the stapler.
Insert the cartridge until the lever of the stapler goes up to be fixed
securely.
1
Open the front cover of the finisher.
2
Slightly raise and pull out the staple cartridge while
holding its lever.
1
2
To Next Page
Loading...
