Toshiba e-STUDIO166 - Page 38

e-STUDIO163/166/203/206 © 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 18
Note: Note:
The density LED blinks while performing adjustment for the items which take time.
Be sure not to turn the power OFF nor perform any other operations while the density LED is
blinking.
Procedure 1
Procedure 2
Procedure 3
Procedure 4
[0][5]
[POWER]
[Digital keys]
Code
[START]
[Digital keys] *
Adjust a value
[INTERRUPT]
Stores
value in RAM
[FUNCTION
CLEAR]
Does not store
value in RAM
[POWER]
OFF/ON
* Press [#] to enter minus (-).
[0][5]
[POWER]
[Digital keys]
Code
[START]
[FUNCTION
CLEAR]
[POWER]
OFF/ON
Value
displayed
[0][5]
[POWER]
[Digital keys]
Code
[START]
[START]
Start
[POWER]
OFF/ON
[START]
Set manually
* Press [#] to enter minus (-).
[Digital keys] *
Adjust a value
[INTERRUPT]
Stores
value in RAM
[FUNCTION
CLEAR]
Does not store
value in RAM
[25
% ] / [200 % ]
[0][5]
[POWER]
[Digital keys]
Code
[START]
[POWER]
OFF/ON
[START]
[Digital keys]
Sub code
* Press [#] to enter minus (-).
[Digital keys] *
Adjust a value
[INTERRUPT]
Stores
value in RAM
[FUNCTION
CLEAR]
Does not store
value in RAM