© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO163/166/203/206
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 19
2
Procedure 6
Procedure 7
Procedure 17
Note: Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
[0][5]
[POWER]
[Digital keys]
Code
[START]
Error
[POWER]
OFF/ON
Automatic
adjustment
[FUNCTION
CLEAR]
[FUNCTION
CLEAR]
Does not store
value in RAM
[0][5]
[POWER]
[Digital keys]
Code
[START]
[CLEAR]
Error
[START]
Start
[POWER]
OFF/ON
Automatic
adjustment
[INTERRUPT]
Stores
value in RAM
[FUNCTION
CLEAR]
Does not store
value in RAM
[0][5]
[POWER]
[Digital keys]
Code
[START]
Adjustment
[POWER]
OFF/ON
Automatic
adjustment
Set manually
[INTERRUPT]
Stores
value in RAM
[FUNCTION
CLEAR]
Does not store
value in RAM
[25
%
] / [200
%
]
06/04
To Next Page
Loading...
