Need help?Do you have a question about the Toshiba E-STUDIO202S and is the answer not in the manual?
General| Brand | Toshiba |
|---|---|
| Model | E-STUDIO202S |
| Category | All in One Printer |
| Language | English |
Lists components and procedures for disassembling the high voltage section, including drum replacement.
Details the procedure for cleaning and replacing the charger wire assembly.
Procedures for disassembling and assembling the operation panel unit and its associated PWB.
Steps to disassemble the optical components, including the copy lamp unit and lens unit, for maintenance.
Lists parts and procedures for disassembling and assembling the fusing section, including rollers and heater lamp.
Lists components and procedures for disassembling/assembling the tray paper feed and transport mechanisms.
Lists parts and procedures for disassembling/assembling the manual paper feed section, including rollers and solenoids.
Lists parts and procedures for disassembling/assembling the rear frame section, including motors and PWBs.
Lists parts and procedures for disassembling/assembling the power supply section, including the power PWB.
Procedures for adjusting copy magnification ratios in main and sub scanning directions.
Adjustments for image position, lead edge void, and center offset using simulation modes.
Procedures for adjusting copy density, main charger bias, and DV bias for optimal output.
Procedure for performing automatic black level correction to ensure white balance accuracy.
Step-by-step guide on how to access and navigate the service simulation mode for diagnostics.
Details simulation codes, their functions, and specific operational procedures for testing components.
Lists error codes and provides detailed explanations, causes, and remedies for specific trouble codes.
Steps for setting serial number on PC and executing firmware download to the machine.
Procedures to acquire firmware version information and EEPROM data from the machine to the PC.
To Next Page
