2.SENDING A FAX
Specifying Recipients 17
2 SENDING A FAX
A contact, for which only a fax number is registered, cannot be displayed in the “Selected Email” and a contact,
for which only an Email address is registered, cannot be displayed in the “Selected Fax”.
You can select a recipient by the following operations:
Selecting a contact by dragging and dropping
Drag a contact in the contact list and drop it to the “Selected Fax” or “Selected Email”.
Selecting a contact by double-clicking on it
Double-click on a contact in the contact list. To change the setting of the recipient to be selected upon double-
clicking, select [Default Configuration], [Type Selection] in the [View] menu and then one of [Fax], [Email] and
[Both].
Selecting a contact from a shortcut menu
Right-click on the contact in the contact list, select [Select] from the shortcut menu and then either [Fax Number]
and [Email].
Removing a recipient
Select a recipient in the “Selected Fax” or “Selected Email” and click the corresponding [Remove] (Left: fax
number, Right: Email address).
3
Click [OK].
The AddressBook Viewer is closed and the recipients selected for “To” are listed.
When the fax transmission is completed, the recipients are automatically removed from the “To” list.
To Next Page
Loading...
Need help?
General
