Toshiba e-STUDIO206 - Preparation 2 - Placing Copy Paper; Acceptable Media Types

Preparation 2 - Placing Copy Paper 31
Preparation 2 - Placing Copy Paper
Place copy paper in an appropriate paper source before you start copying.
Acceptable media types
Standard size plain paper (64 to 80 g/m
2
) can be used for the drawers in the equipment and the
Paper Feed Unit (optional). See the table below for the details.
*1 “Maximum sheet capacity” refers to the maximum number of sheets when TOSHIBA-recommended
paper is used. See the following page for the TOSHIBA-recommended paper:
 P.32 “Recommended paper”
*2 50 to 63 g/m
2
paper can be used if it is set on the bypass tray sheet by sheet.
*3 Be sure to use the overhead transparencies that TOSHIBA recommends. When transparencies other
than the TOSHIBA-recommended ones are used, this could cause an equipment malfunction.
y You cannot mix various paper sizes in one drawer.
y “LT format” is the standard size for only use in North America.
Abbreviations for LT format sizes:
LT: Letter, LD: Ledger, LG: Legal, ST: Statement, COMP: Computer
Feeder Media type Paper size
Maximum sheet
capacity
*1
Drawers of
the equip-
ment and
Paper Feed
Unit
(optional)
Plain paper
(64 - 80 g/m
2
)
A/B format:
A3, A4, A4-R, B4, B5, B5-R, FOLIO
LT format:
LD, LG, LT, LT-R, COMP, 13"LG
250 sheets (64 g/m
2
)
250 sheets (80 g/m
2
)
Bypass tray Plain paper
(64 - 80 g/m
2
)
*2
A/B format:
A3, A4, A4-R, A5-R, B4, B5, B5-R, FOLIO
LT format:
LD, LG, LT, LT-R, ST-R, COMP, 13"LG
100 sheets (64 g/m
2
)
100 sheets (80 g/m
2
)
THICK PAPER 1
(81 - 105 g/m
2
)
1 sheet
(81 - 105 g/m
2
)
THICK PAPER 2
(106 - 163 g/m
2
)
1 sheet
(106 - 163 g/m
2
)
Tracing paper
(75 g/m
2
)
1 sheet
Sticker labels 1 sheet
Transparencies
*3
A4 only
1 sheet