e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
CONTROL PANEL
5 - 4
24 Close Large Capacity
Feeder
LCF drawer is not installed when
feeding from LCF is set
Cleared by installing LCF drawer
25 Close Large Capacity
Feeder Door
LCF cover is open when feeding from
LCF is set
Cleared by closing the cover
26 Place Doc. Feeder in the
down position
RADF is open when original is placed
on RADF
Cleared by closing RADF
27 Insert key copy counter Key copy counter not inserted Cleared by inserting key copy
counter
28 Place originals in the docu-
ment feeder
Displayed when the conditions are
set and START button is pressed
with no original placed
Cleared by setting the original
29 Change direction of original Displayed when the direction of origi-
nal placed is different from the setting
30 PRESS [BASIC] and select
normal paper size
Displays the warning that the copy is
not enabled when any drawer but
bypass feed is selected at Cover
Sheet Copying Mode or Sheet Inser-
tion Mode
31 %d originals are scanned
Start copy job from next
page
Paper jam occurred during copying
(RADF scanning)
32 Add paper Displayed when the paper in
selected drawer is running out
33 Cannot duplex this size Displayed when the paper size which
is not specified for duplex copying is
set
34 Cannot use this media type Displayed when the paper size which
is not specified for the functions such
as stapling or hole punching is set
35 Set standard size Displayed when the paper size which
is not acceptable is set (depends on
the setting)
Re-set the paper size
36 Cannot staple this paper
type
Displayed when the paper type which
can not be stapled is set at Cover
Sheet Copying Mode/Sheet Inser-
tion Mode
Re-set the paper type
37 Cannot duplex copy Displayed when the paper type which
can not be duplexed is set at Cover
Sheet Copying Mode/Sheet Inser-
tion Mode
Re-set the paper type
38 Cannot use transparency
film
Displayed when the paper type which
can not be punched is set at Cover
Sheet Copying Mode/Sheet Inser-
tion Mode
Re-set the paper type
39 Copy size: A4/LT only Displayed when the paper size which
is not specified for “Book-type duplex
copying” or “Dual-page” is set
40 Copy size: A4/LT and A4-
R/LT-R
Displayed when the paper size which
is not specified for “Rotate Sort”
41 CHANGE DRAWER TO
CORRECT PAPER SIZE
Displayed when the selected paper
size is not in the drawer
42 Change the paper type Displayed when the selected media
type is not in the drawer
43 Select a paper size for
bypass feeding
Displayed when paper size needs to
be specified for bypass feeding such
as duplex copying
No. Message State of equipment Note
To Next Page
Loading...
