5
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
CONTROL PANEL
5 - 5
44 Place the blank sheets in
bypass tray and select the
paper size
Displayed when no paper is in the
selected feeder at Cover Sheet
Copying Mode
45 Place the blank sheets in
the same direction as the
originals
Displayed when the direction of
cover page is different from that of
other pages at Cover Copying Mode
46 Place the same size blank
sheets as the originals
Displayed when the paper size of
cover page is different from that of
other pages at Cover Copying Mode
47 Place insertion sheets in
the bypass tray and select
the paper size
Displayed when no insertion sheet is
in the selected drawer at Sheet Inser-
tion Mode
48 Select the same size
insert1 sheets as the origi-
nals
Displayed when the size of insertion
sheet (sheet 1) is different from that
of other pages at Sheet Insertion
Mode
49 Select the same size
insert2 sheets as the origi-
nals
Displayed when the size of insertion
sheet (sheet 2) is different from that
of other pages at Sheet Insertion
Mode
50 Set insert1 sheets in the
same direction as the origi-
nals
Displayed when the direction of
insertion sheet (sheet 1) is different
from that of other pages at Sheet
Insertion Mode
51 Set insert2 sheets in the
same direction as the origi-
nals
Displayed when the direction of
insertion sheet (sheet 2) is different
from that of other pages at Sheet
Insertion Mode
52 READY
(CHANGE THE PAPER
TYPE)
Displays when the printing is stopped
because of media type mismatch
53 Set transparency film in A4/
LT direction
Displayed when the selected paper
size is other than A4/LT at OHP
mode
54 CHECK PAPER IN LARGE
CAPACITY FEEDER
Papers in LCF are set incorrectly
55 CANNOT PUNCH THIS
SIZE PAPER
Displayed when the selected paper
size is not specified for hole punching
56 Remove paper from the fin-
isher
Displayed when the paper sizes are
mixed at Staple Sorting Mode
57 Cannot staple this size Displayed when the paper size is not
specified for stapling at Staple Sort-
ing Mode
58 Remove paper from the fin-
isher
Finisher is full of papers
59 Examine stapler Trouble in the stapler unit in finisher
60 Check staple cartridge No stapler in finisher section
61 Job interrupted job 1 saved Interrupt copying is accepted
62 Ready to resume job 1 Interrupt copying is cancelled (fin-
ished)
63 Cannot use AMS mode Displayed when reproduction ratio is
set to be over 200% at AMS Mode on
RADF
Set the reproduction ratio 200% or
below manually
64 More than 200% is not
available
Displayed when reproduction ratio is
set manually to be over 200% on
RADF
Set the reproduction ratio 200% or
below
No. Message State of equipment Note
To Next Page
Loading...
