6
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
SCANNER
6 - 25
[G] Mirror-1
[H] Inverter board
Notes:
1. When installing the carriage-1, fix the
bracket temporarily at the position (A).
Then move it to the direction (B) slowly,
push it to the end of frame and fix at this
position with the screws.
2. Refer to the “3.7.1 Carriages” in the Ser-
vice Handbook
3. Rotate the drive pulley to move the car-
riage.
Fig. 6-41
(1) Take off the carriage-1
( P.6-22 "[F] Carriage-1").
Note:
When replacing the mirror-1, replace it
together with the carriage-1. The mirror-1
should not be removed separately.
(1) Take off the carriage-1
( P.6-22 "[F] Carriage-1").
(2) Disconnect 2 connectors.
(3) Remove 2 screws and take off the inverter
board.
Fig. 6-42
(
B
)
(
A
)
(
A
)
Bracket
Bracket
Inverter board
To Next Page
Loading...
