e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
SCANNER
6 - 26
[I] Carriage wire / Carriage-2
(1) Take off the carriage-1
( P.6-22 "[F] Carriage-1").
(2) Install the wire holder jig to each pulley on
front and rear sides, not to loosen the car-
riage wire.
Note:
Refer to “3.7.1 Carriages” in the Service
Handbook for the installation direction of the
wire holder jig.
Fig. 6-43
(3) Remove the tension springs on both front
and rear sides.
(4) Remove the carriage wires on both front and
rear sides.
Fig. 6-44
(5) Rotate the carriage-2 in the direction where
the inside of the frame is dented shown in
the figure at right, not to touch the mirror.
Then take off the carriage-2.
Fig. 6-45
Wire holder jig
Tension spring
Carriage wire
Carriage wire
Tension spring
Carriage-2
To Next Page
Loading...
