6
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
SCANNER
6 - 27
[J] Mirrors-2 and -3
[K] Platen sensor
[L] Carriage home position sensor
(1) Take off the carriage-2
( P.6-26 "[I] Carriage wire / Carriage-2").
Note:
When replacing the mirrors-2 and -3, replace
them together with the carriage-2. The mir-
rors-2 and –3 should not be removed sepa-
rately.
(1) Take off the rear cover an upper rear cover
( P.2-31 "[C] Rear cover", P.2-34 "[I]
Upper rear cover").
(2) Disconnect 1 connector from the platen sen-
sor on the left rear position of the equipment
upper side.
(3) Release the latches of the sensor and take
off the platen sensor.
Fig. 6-46
(1) Take off the rear cover upper rear cover
( P.2-31 "[C] Rear cover", P.2-34 "[I]
Upper rear cover").
(2) Disconnect 1 connector from the carriage
home position sensor on the left rear position
of the equipment upper side.
(3) Release the latches of the sensor and take
off the carriage home position sensor.
Fig. 6-47
Platen sensor
Carriage home position sensor
To Next Page
Loading...
