6
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
SCANNER
6 - 29
[N] Scanning section control PC board (SLG board)
(1) Take off the lens cover
( P.6-18 "[B] Lens cover")
(2) Disconnect 8 connectors from the SLG
board.
(3) Remove 6 screws and take off the SLG
board.
Note:
The SLG board for e-STUDIO200L/230/280
series and the one for e-STUDIO202L/203L/
232/233/282/283 series are different. To
avoid confusion, the color of the connector
CN19 on the SLG board for e-STUDIO202L/
203L/232/233/282/283 series is yellow.
Fig. 6-51
SLG board
07/11
To Next Page
Loading...
