8
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
LASER OPTICAL UNIT
8 - 11
[C] Internal cooling fan-2
(1) Take off the rear cover
( P.2-31 "[C] Rear cover").
(2) Remove 1 screw and take off the harness
clamp. Take off the duct upper cover and
ozone filter.
Fig. 8-16
(3) Disconnect 1 connector and remove 2
screws, and then take off the duct and the
internal cooling fan-2.
Fig. 8-17
Duct upper cover
Ozone filter
Internal cooling fan-2
Duct
Screw
Screw
Connetor
04/07
To Next Page
Loading...
