e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
9 - 34
[X] Registration sensor
(18) Slide the registration roller (metal) to the rear
side. Then remove the gear.
Fig. 9-68
(19) Pull out the registration roller (metal) to the
front side.
Fig. 9-69
(1) Take off the registration rollers (rubber one
and metal one)
( P.9-31 "[W] Registration roller").
(2) Disconnect 1 connector and remove 3
screws and take off the registration guide L.
Fig. 9-70
Gear
Registration roller
(
metal
)
Registration roller
(
metal
)
Registration guide L
To Next Page
Loading...
