Toshiba e-STUDIO233 - Page 268

e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DRUM RELATED SECTION
11 - 18
[P] 1st transport sensor
[Q] Exhaust fan
(1) Take off the transfer unit
( P.11-17 "[O] Transfer unit").
(2) Extend the holder part to release the hook of
the protrusion.
(3) Rotate the guide and lift it up to take off.
Fig. 11-32
(4) Disconnect 1 connector, release the latch,
and then take off the 1st transport sensor.
Fig. 11-33
(1) Take off the ozone filter
( P.11-15 "[L] Ozone filter").
(2) Take off the transfer/separation charger (
P.11-15 "[M] Transfer/Separation charger").
(3) Take off the transfer unit
( P.11-17 "[O] Transfer unit").
(4) Take off the guide
( P.11-18 "[P] 1st transport sensor").
(5) Remove the plate spring.
Fig. 11-34
Holder
Guide
1st transport sensor
Plate spring
05/07