12
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
DEVELOPMENT SYSTEM
12 - 13
[G] Guide roller / Developer sleeve
(1) Remove the developer material
( P.12-10 "[C] Removing developer mate-
rial").
(2) Remove 2 screws and take off the recovered
toner supply unit.
Fig. 12-16
(3) Remove 1 screw. Disconnect 1 connector
while taking off the recovered toner drive
unit. Remove 1 gear.
Fig. 12-17
(4) Remove 2 plate springs fixing the doctor
sleeve on its both ends.
Fig. 12-18
Recovered toner
supply unit
Gear
Recovered toner drive unit
Connector
Plate spring
Plate spring
To Next Page
Loading...
