e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DEVELOPMENT SYSTEM
12 - 20
[I] Replacement of Oil Seal
(11) Remove the bushing on the rear side.
(12) Remove the oil seal.
(Replacement of Oil Seal: P.12-20 "[I]
Replacement of Oil Seal")
Fig. 12-37
(1) Insert a fine screwdriver into the depression
of the oil seal to take it out.
(2) Push in a new oil seal parallel to the frame or
bushing (shown figure at right).
(3) Apply the grease (Alvania No.2; amount of 2
rice grains) on entire surface of the oil seal
evenly.
Note:
Wipe off the excessive grease.
Fig. 12-38
Oil seal
Bushing
OutsideInside
Oil seal
Grease
To Next Page
Loading...
