12
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
DEVELOPMENT SYSTEM
12 - 19
(7) Remove 2 bushings and 2 oil seals on the
rear side.
(Replacement of Oil Seal: P.12-20 "[I]
Replacement of Oil Seal"
Fig. 12-34
(8) Remove the end section of the mixer-1.
(9) Remove the bushing and oil seal.
(Replacement of Oil Seal: P.12-20 "[I]
Replacement of Oil Seal")
Fig. 12-35
(10) Take off the mixer-1.
Fig. 12-36
Oil seal
Bushing
Oil sealBushing
End section of mixer-1
Mixer-1
To Next Page
Loading...
