e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DEVELOPMENT SYSTEM
12 - 18
(3) Remove 1 screw and take off the tensioner
bracket.
(4) Remove 2 screws and take off the holder.
Fig. 12-31
(5) Remove 2 bushings and 2 oil seals from the
holder.
(Replacement of Oil Seal: P.12-20 "[I]
Replacement of Oil Seal")
Fig. 12-32
(6) Take off the mixers-2 and -3.
Fig. 12-33
Holder
Tensioner bracket
Oil seal
Bushing
Mixer-3
Mixer-2
To Next Page
Loading...
