13
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
FUSER UNIT
13 - 17
[I] Thermostat
(3) Take out the thermistor by removing 1 screw
each.
Note:
When installing the thermistors, check the
length of the harness first and distinguish the
installation positions of the side thermistor
and edge thermistor by the length of each
harness.
Fig. 13-23
Fig. 13-24
(1) Take off the pressure roller
( P.13-15 "[F] Pressure roller").
(2) Place the fuser unit upside down. Release
the latch and take off the harness cover.
Fig. 13-25
Thermistor
Center thermistor
Side thermistor
Edge thermistor
Harness cover
To Next Page
Loading...
