e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
FUSER UNIT
13 - 18
(3) Remove 4 screws (2 of them on the front
side are the stepped screws) and take off the
fuser unit lower cover.
Fig. 13-26
(4) Take off 2 thermostats by removing 2 screws
each.
Fig. 13-27
Note:
The gap between the fuser roller and ther-
mostat is adjusted to be 2.3±0.2 mm with the
screw in the figure at right. Therefore, make
sure not to loosen 4 screws shown in the fig-
ure at right.
Fig. 13-28
Fuser unit lower cover
Stepped screw
Thermostat
To Next Page
Loading...
