How to fix a 'MISFEED Exxxx' error on a Toshiba All in One Printer?
If your Toshiba All in One Printer displays a 'MISFEED Exxxx' error, it indicates a paper or original misfeed. The solution is to carefully remove any misfed paper or originals from the printer.
What to do if my Toshiba e-studio2505f All in One Printer says 'DRAWER # EMPTY ADD PAPER'?
If your Toshiba All in One Printer shows 'DRAWER # EMPTY ADD PAPER', it means the designated drawer is out of paper or the drawer isn't properly inserted. You should load paper into the drawer or firmly re-insert it. Note that memory reception may occur. Also, avoid turning off the power.
Why does my Toshiba e-studio2505f All in One Printer say 'MEMORY IS FULL'?
If your Toshiba All in One Printer displays 'MEMORY IS FULL', it means the memory filled up during data entry or transmission. Press any key to return to the idle state. If it occurs during transmission, wait for memory to become available and retry, or use direct transmission. If it happens during reception, ask the sender to re-transmit the document.
What does 'ERROR:CHECK COPY MODE' mean on my Toshiba e-studio2505f?
When the Toshiba All in One Printer displays 'ERROR: CHECK COPY MODE', it indicates an error such as a misfeed or low toner. To address this, press the [COPY] button to check the error.
What does 'COUNT OVER' mean on my Toshiba e-studio2505f?
The 'COUNT OVER' message on your Toshiba All in One Printer means the number of scanned pages has exceeded the limit of 50 sheets. You can either cancel the job (CANCEL JOB) or stop the scanning and send the already stored images (SEND).
What to do if my Toshiba e-studio2505f All in One Printer shows 'FAX ERROR xxxx'?
If your Toshiba All in One Printer displays 'FAX ERROR xxxx', it means a communication error occurred during sending or receiving a fax. Try sending or receiving the fax again.
Why does my Toshiba All in One Printer say 'PUT DOCUMENT FEEDER DOWN'?
The message 'PUT DOCUMENT FEEDER DOWN' on your Toshiba All in One Printer indicates that the ADF/RADF or its cover is open after placing the originals. Close the ADF/RADF or its cover.
What does 'PUT ORIGINAL ON GLASS' mean on my Toshiba e-studio2505f?
The 'PUT ORIGINAL ON GLASS' message on your Toshiba All in One Printer means an original was detected in the ADF/RADF feed tray when "NEXT ORIGINAL?" was displayed. Remove the original from the ADF/RADF feed tray.
What to do if my Toshiba e-studio2505f (e-STUDIO2507 Series) says 'LOAD XX'?
If your Toshiba All in One Printer (e-STUDIO2507 Series) displays 'LOAD XX', it means the paper size isn't correct for the received original. Change the paper size setting to match the request.
General| Brand | Toshiba |
|---|---|
| Model | e-studio2505f |
| Category | All in One Printer |
| Language | English |
To Next Page
