Toshiba E-STUDIO3008A - Reducing the Scan Noise; Canceling the ADF Scan Noise Reduction

120 Reducing the Scan Noise
0.Reducing the Scan Noise
You can set the scan noise reduction level for scanning originals with the ADF at copying. Scan noise can be reduced if
it is conspicuous on images due to fine dust.
1
Press [ADF NOISE REDUCTION] in the IMAGE menu.
2
Press [LOW], [MIDDLE], or [HIGH] to adjust the scan noise reduction level, and then press [OK].
Fine lines other than scan noise may become faint if you set the scan noise reduction level higher.
 Canceling the ADF scan noise reduction
Press [NONE] or [RESET], and then [OK].