2 SETTING ITEMS (ADMIN)
162 Setting Network Functions
3
Specify the following items as required and press [OK].
POLICY NAME — IPsec policy name currently applied is displayed.
[ENABLE] — Press this button to enable IPsec communication.
[DISABLE] — Press this button to disable IPsec communication.
[FLUSH CONNECTIONS] — Press this button to manually clear (flush) the current IPsec session, for starting a
new session.
[FACTORY DEFAULT] — Press this button to reset the IPsec settings back to the factory defaults.
When you press [FACTORY DEFAULT], a message asking you to perform the operation is displayed.
4
Continue to another network setting if required, then press [APPLY NOW].
“NETWORK INITIALIZING” is displayed at the lower left of the screen and this equipment starts initializing the
network interface card to apply the changes. This message disappears after it is finished.
To Next Page
Loading...
