2.TopAccess
[Administration] Tab 15
TopAccess
VNC Setting
You can use a computer or a mobile terminal such as a tablet and a smartphone to check and operate the control
panel.
The default password for this VNC function is “d9kvgn”. Be sure to change it before using this function. Specify a
password with six or more and eight or less alphanumeric letters.
You can use only one computer or mobile terminal for the VNC function.
It is recommended that you use UltraVNC (client software) on Windows 8.1 or later for the VNC function.
When this VNC function is enabled, the equipment does not enter the Super Sleep mode.
Item name Description
1 Enable VNC Function Select whether the VNC function is enabled or disabled.
Enable — Enables the VNC function.
Disable — Disables the VNC function.
2 Old Password Enter the old password for the VNC function.
3 New Password Enter a new password for the VNC function.
4 Retype Password Retype the new password for the VNC function.
5 Enable SSL/TLS Select whether the SSL (Secure Sockets Layer)/TLS (Transport Layer Security)
is enabled or disabled for the VNC function.
Enable — Enables the VNC function.
Disable — Disables the VNC function.
6 Enable Remote Panel
Operation
Select whether the remote panel operation function is enabled or disabled.
Enable — Select this to enable the remote panel operation function.
Disable — Select this to disable the remote panel operation function.
For the details about [Enable Remote Panel Operation], contact your service technician or representative.
7 Open Range Select the disclosure range of the remote panel operation function.
Admin — Permits the administrator.
User — Permits general users.
8 Intermediate Server Address Enter an IP address and port number of the relay server used for the remote
panel operation.
To Next Page
Loading...
